SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014SANTA FE XL PREMIUMREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM DIAGNOSIS (1 OF 3)DTC P0113: INTAKE AIR TEMPERATURE SENSOR 1 CIRCUIT HIGH INPUTCOMPONENT INSPECTION
2014 Hyundai Santa Fe XL Premium

Component Inspection

2014 Hyundai Santa Fe XL PremiumSECTION Component Inspection
  • Check IATS resistance 
    1. IG "OFF". Disconnect IATS connector.
    2. Measure resistance between signal and ground terminals of IATS connector after checking the temperature of IATS with GDS (Component Side)
      TEMPERATURE RESISTANCE SPECIFICATION

      Temp. (°C) Resistance (kΩ)
      -20 (-4°F) 13.8 ~ 16.0
      20 (68° F) 2.31 ~ 2.56
      60 (140°F) 0.54 ~ 0.61
      - -
    3. Is the measured resistance within specification?

      YES 

      • Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO 

      • Substitute with a known - good IATS and check for proper operation. If the problem is corrected, replace IATS and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.