Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014SANTA FE XL PREMIUMREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEFUEL DELIVERYFUEL DELIVERY SYSTEMFUEL PUMPREPAIR PROCEDURESINSPECTION[FUEL PUMP MOTOR]
2014 Hyundai Santa Fe XL Premium
[Fuel pump motor]
2014 Hyundai Santa Fe XL PremiumSECTION [Fuel pump motor]
- Turn the ignition switch OFF, and then remove battery (-) cable.
- Remove the fuel pump assembly.
- Check motor operation by fuel pump connector (A) connecting power (No. 4) and ground (No. 5).
Courtesy of HYUNDAI MOTOR AMERICA
Pin No. Description 1 - 2 Fuel sender signal 3 Fuel sender ground 4 Fuel pump motor (+) 5 Fuel pump motor ground
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.