Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014GENESIS 3.8REPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSKEYLESS ENTRY AND BURGLAR ALARMREPAIR PROCEDURESINSPECTIONREAR DOOR LOCK SWITCH INSPECTION
2014 Hyundai Genesis 3.8
Rear Door Lock Switch Inspection
2014 Hyundai Genesis 3.8SECTION Rear Door Lock Switch Inspection
- Remove the rear door trim panel. (Refer to the REAR DOOR )
- Disconnect the 7P connector from the actuator.
- Check for continuity between the terminals in each switch position according to the table.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.