Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHYUNDAI2014GENESIS 3.8REPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALFUSES & CIRCUIT BREAKERSFUSES AND RELAYSPDM RELAY BOXDESCRIPTION AND OPERATIONDESCRIPTION

2014 Hyundai Genesis 3.8

Description and Operation: Description

2014 Hyundai Genesis 3.8SECTION Description

The PDM, which installed beside the audio head unit, is united with IG1, IG2, ACC and Sub start relay. This module receive signal from IPM and control relay (ACC/IG1/IG2/ST).

Fig 1: Identifying PDM Relay Box And Audio Head Unit

Courtesy of HYUNDAI MOTOR AMERICA

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.