General Information: DTC Detecting Condition

2014 Hyundai Genesis 3.8SECTION DTC Detecting Condition
Item Detecting Condition Possible Cause
DTC Strategy
  • Signal monitoring
  • Open or short in the longitudinal G Sensor circuit
  • Faulty the longitudinal G sensor (Installed in the yaw-rate sensor & lateral G sensor & longitudinal G sensor)
Threshold valve
  • when the output signal of the longitudinal G sensor is out of the normal range
Fail-Safe
  • The AVH (Automatic Vehicle Hold) function is inhibited.
  • Warning lamp "OFF"
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.