Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014EQUUS SIGNATUREREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLELECTRONIC STABILITY CONTROL (ESC) SYSTEMTROUBLESHOOTINGFAILURE DIAGNOSISEVEN AFTER THE ENGINE IS STARTED, THE ABS WARNING LAMP REMAINS ONINSPECTION PROCEDURESCHECK DTC OUTPUT
2014 Hyundai Equus Signature
Check DTC Output
2014 Hyundai Equus SignatureSECTION Check DTC Output
- Connect the GDS to the 16P data link connector located behind the driver's side kick panel.
- Check the DTC output using GDS.
- Is DTC output?
NO
- Check the CAN circuit resistance for ABS warning lamp.
YES
- Perform the DTC troubleshooting procedure (Refer to DTC INDEX DTC troubleshooting).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.