Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Signal Circuit Inspection
2014 Hyundai Equus SignatureSECTION Signal Circuit Inspection
- IG key "ON", Engine "OFF".
- Perform "Oscilloscope" procedure in the "Vehicle S/W Management" with GDS.
- Measure the signal waveform between CAN High terminal of "CLOCK SPRING (STEERING WHEEL REMOTE CONTROL)" harness connector and chassis ground.
- Measure the signal waveform between CAN LOW terminal of "CLOCK SPRING (STEERING WHEEL REMOTE CONTROL)" harness connector and chassis ground.
■ Reference data
- Does the measured signal waveform follow the reference data?
YES
- Disconnect CAN communication units one by one and monitor DTC to find the cause.
- If the DTC erase, substitute with a known-good unit and check for proper operation. If the problem is corrected, replace the unit and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Check short to battery/ground. Repair as necessary, Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.