General Information: DTC Detecting Condition

2014 Hyundai Azera LimitedSECTION DTC Detecting Condition
Item Detecting Condition Possible Cause
DTC Strategy
  • Signal High
  1. Poor connection
  2. Open or short to battery in signal harness
  3. Open in ground harness
  4. Faulty OTS
  5. PCM
Enable Conditions Case 1
  • Engine running state > 60 sec
  • Coolant temperature < 110 °C (230°F)
Case 2
  • Engine running state > 90 sec
Threshold value
  • Oil temperature sensor's signal > 4.9V
Diagnosis Time
  • Continuous (More than 12.5 sec. failure for every 15 sec. test)
MIL On Condition
  • 2 Drive Cycles
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.