Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Inspection
2014 Hyundai Azera LimitedSECTION Component Inspection
- Check IATS resistance
- IG "OFF" and disconnect IATS connector.
- Measure resistance between signal and ground terminals of IATS connector after checking out the temperature of IATS with GDS (Component Side)
Specification:
Temp. (°C) Resistance (kΩ) Temp. (°C) Resistance (kΩ) -40 40.93 ~ 48.35 20 2.31 ~ 2.57 -20 13.89 ~ 16.03 40 1.08 ~ 1.21 0 5.38 ~ 6.09 60 0.54 ~ 0.66 10 3.48 ~ 3.90 80 0.29 ~ 0.34 - Is the measured resistance within specification?
YES
- Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known - good IATS and check for proper operation. If the problem is corrected, replace IATS and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.