Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSHYUNDAI2014AZERA LIMITEDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEIGNITION SYSTEMENGINE ELECTRICAL SYSTEM - GENERAL INFORMATIONTROUBLESHOOTINGSYMPTOMS OF STARTING SYSTEM
2014 Hyundai Azera Limited
Symptoms Of Starting System
2014 Hyundai Azera LimitedSECTION Symptoms Of Starting System
SYMPTOMS OF STARTING SYSTEM
| Symptom | Suspect area | Remedy |
|---|---|---|
| Engine will not crank | Battery charge low | Charge or replace battery |
| Battery cables loose, corroded or worn out | Repair or replace cables | |
| Transmission range switch (Vehicle with automatic transmission only) | Refer to AUTOMATIC TRANSAXLE . | |
| Fuse blown | Replace fuse | |
| Starter motor faulty | Replace | |
| Ignition switch faulty | Replace | |
| Engine cranks slowly | Battery charge low | Charge or replace battery |
| Battery cables loose, corroded or worn out | Repair or replace cables | |
| Starter motor faulty | Replace | |
| Starter keeps running | Starter motor | Replace |
| Ignition switch | Replace | |
| Starter spins but engine will not crank | Short in wiring | Repair wiring |
| Pinion gear teeth broken or starter motor | Replace | |
| Ring gear teeth broken | Replace drive plate or torque converter |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.