SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014AZERA LIMITEDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALMECHANICALTIMING SYSTEMTIMING CHAINREPAIR PROCEDURESINSTALLATION
2014 Hyundai Azera Limited

Repair Procedures: Installation

2014 Hyundai Azera LimitedSECTION Installation
  1. Install the jack to the edge of upper oil pan to support the engine.
    NOTE: Insert the rubber block between jack and upper oil pan.
  2. The key (A) of crankshaft should be aligned with the timing mark (B) of block. As a result of this, the piston of No. 1 cylinder is placed at the top dead center on compression stroke.
    Fig 1: Identifying Crankshaft Key And Block Timing Mark
    G08809169Courtesy of HYUNDAI MOTOR AMERICA
  3. Install the tensioner adapter assembly (A).
    Fig 2: Identifying Tensioner Adapter Assembly
    G08809170Courtesy of HYUNDAI MOTOR AMERICA
  4. Install the crankshaft sprocket (A). (LH camshaft drive).
    Fig 3: Identifying Crankshaft Sprocket (LH Camshaft Drive)
    G08809171Courtesy of HYUNDAI MOTOR AMERICA
  5. Install the LH timing chain (A).
    Fig 4: Identifying LH Timing Chain
    G08809172Courtesy of HYUNDAI MOTOR AMERICA
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.