Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014AZERA LIMITEDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATSBODY - INTERIOR & EXTERIOR - GENERAL INFORMATIONGENERAL INFORMATIONSPECIAL SERVICE TOOLS
2014 Hyundai Azera Limited
Special Service Tools
2014 Hyundai Azera LimitedSECTION Special Service Tools
| Tool (Number and name) | Illustration | Use |
|---|---|---|
| 09861-31100 Seal any cut-out tool |
Cutting windshield sealant (use with 09861-31200) |
|
| 09861-31200 Sealant cutting blade |
Cutting windshield sealant (use with 09861-31100) |
|
| 09861-31000 Windshield molding remover |
Windshield molding removal | |
| 09880-4F000 Hog ring clip installer |
Hog ring clip installation | |
| 09816-2P100 Power silent cutting tool |
Tool box for removing panoramaroof | |
| 09816-2P110 Air power tool |
Air tool for installing blade | |
| 09816-2P121 Cutter-1 |
Blade for removing the front and side area of panoramaroof (This blade has a inclination to push upward.) | |
| 09816-2P122 Cutter-2 |
Blade for removing the front and side area of panoramaroof (This blade has a inclination to push downward.) | |
| 09816-2P123 Cutter-3 |
Blade for removing the front and side area of panoramaroof (This blade has a inclination to push downward.) | |
| 09816-2P124 Cutter-4 |
Blade for removing the front and side area of panoramaroof (This blade has a inclination to push downward.) | |
| 09816-2P127 Cutter-5 |
Blade for removing the rear area of panoramaroof | |
| 09816-2P130 Cutter-10 |
Blade for removing the edge area of panoramaroof |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.