SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014AZERA LIMITEDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSKEYLESS ENTRY & BURGLAR ALARMTRANSMITTERREPAIR PROCEDURESTRANSMITTER CODE REGISTRATION (USING GDS)
2014 Hyundai Azera Limited

Transmitter Code Registration (Using GDS)

2014 Hyundai Azera LimitedSECTION Transmitter Code Registration (Using GDS)
  1. Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on GDS.
    Fig 1: Locating Data Link Connector
    G08814219Courtesy of HYUNDAI MOTOR AMERICA
  2. Select the vehicle model and then do "CODE SAVING"
    Fig 2: Display - Transmitter Code Saving Selection Screen
    G08814220Courtesy of HYUNDAI MOTOR AMERICA
  3. After selecting "CODE SAVING" menu, button "ENTER" key, then the screen will be shown as below.
    Fig 3: Display - Transmitter Code Saving Menu Screen
    G08814221Courtesy of HYUNDAI MOTOR AMERICA
  4. After removing the ignition key from key cylinder, push "ENTER" key to proceed to the next mode for code saving. Follow steps  1 to 4 and then code saving is completed.
    Fig 4: Display - Transmitter Code Saving Completion Screen
    G08814222Courtesy of HYUNDAI MOTOR AMERICA
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.