Check The CAN Circuit Wiring For ABS Warning Lamp

2014 Hyundai Azera BaseSECTION Check The CAN Circuit Wiring For ABS Warning Lamp
  1. Disconnect the instrument cluster connector (M08) and ESC HECU connector, and then turn the ignition switch OFF.
  2. Check for continuity between terminal (M08) 33 of the cluster harness side connector and terminal 26 of ESC HECU harness side.

    Check for continuity between terminal (M08) 34 of the cluster harness side connector and terminal 14 of ESC HECU harness side.

    Specification:Β  Below 1Ξ©

  3. Is resistance within specification?

    YESΒ 

    • Repair short of wiring between terminal 26, 14 of ESC HECU harness connector and ABS warning lamp module.

    NOΒ 

    • Repair open of wiring between terminal 26, 14 of ESC HECU harness connector and ABS warning lamp module.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.