Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014ACCENT SE, STANDARD TRANSREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (1 OF 2)DTC P0341: CAMSHAFT POSITION SENSOR A CIRCUIT RANGE/PERFORMANCE (BANK 1)WIRING INSPECTIONGROUND CIRCUIT INSPECTION
2014 Hyundai Accent SE, Standard Trans
Ground Circuit Inspection
2014 Hyundai Accent SE, Standard TransSECTION Ground Circuit Inspection
- IG KEY "OFF".
- Disconnect CMPS connector.
- IG KEY "ON" & ENG "OFF"
- Measure the voltage between signal terminal of CMPS harness connector and chassis ground. (A)
- Measure the voltage between signal and ground terminal of CMPS harness connector and chassis ground. (B)
Specification: "A" - "B" = Below 200mV
- Is the measured voltage within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair Open in ground circuit and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.