SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014ACCENT SE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEMENGINE CONTROL MODULE (ECM)REPAIR PROCEDURESINSTALLATION
2014 Hyundai Accent SE, Standard Trans

Repair Procedures: Installation

2014 Hyundai Accent SE, Standard TransSECTION Installation
CAUTION: When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
  1. Perform "ECM Neutral mode" procedure with GDS. (Refer to NEUTRALIZING OF ECM in IMMOBILIZER SYSTEM article )
  2. After finishing "ECM Neutral mode", perform "Key teaching" procedure with GDS. (Refer to TEACHING PROCEDURES )

[In the case of installing new ECM]
Perform "Key teaching" procedure with GDS. (Refer to TEACHING PROCEDURES .
  1. Installation is reverse of removal.

    ECM installation bolt: 

    9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    ECM bracket installation bolt: 

    9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.