Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014ACCENT SE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESDIFFERENTIALS & DRIVE AXLESDRIVESHAFT & AXLE - GENERAL INFORMATIONTROUBLESHOOTING
2014 Hyundai Accent SE, Standard Trans
Driveshaft & Axle - General Information: Troubleshooting
2014 Hyundai Accent SE, Standard TransSECTION Troubleshooting
| Trouble Symptom | Probable cause | Remedy |
|---|---|---|
| Vehicle pulls to one side | Scoring of driveshaft ball joint | Replace |
| Wear, rattle or scoring of wheel bearing | Replace | |
| Defective front suspension and steering | Adjustment or Replace | |
| Vibration | Wear, damage or bending of driveshaft | Replace |
| Driveshaft rattle and hub serration | Replace | |
| Wear, rattle or scratching of wheel bearing | Replace | |
| Shimmy | Defective wheel balance | Adjustment or Replace |
| Defective front suspension and steering | Adjustment or Replace | |
| Excessive noise | Wear, damage or bending of driveshaft | Replace |
| Rattle of driveshaft and worn hub splines | Replace | |
| Wear, rattle or scoring of wheel bearing | Replace | |
| Loose hub nut | Adjustment or Replace | |
| Defective front suspension and steering | Adjustment or Replace |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.