SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2013VELOSTER TURBO, AUTOMATIC TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 14 (AIRBAG MODULES & CLOCK SPRING)SIDE AIRBAG (SAB) MODULEREPAIR PROCEDURESREMOVAL
2013 Hyundai Veloster Turbo, Automatic Trans

Repair Procedures: Removal

2013 Hyundai Veloster Turbo, Automatic TransSECTION Removal
WARNING: This page is about a different car, the 2012 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The side airbag cannot be disassembled from the seat back assembly, so replace assembly when replacing the side airbag.
  1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
  2. Remove the front seat assembly.

    (Refer to the Body group - "SEAT ")

  3. Remove the seat back assembly.

    (Refer to the Body group - "SEAT ")

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.