Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHYUNDAI2013SANTA FE XL PREMIUMREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSAXLE SYSTEM DIAGNOSISDTC P0880: TCM POWER SIGNAL ERROR OPEN/SHORT (GND)WIRING INSPECTIONPOWER CIRCUIT INSPECTION

2013 Hyundai Santa Fe XL Premium

Power Circuit Inspection

2013 Hyundai Santa Fe XL PremiumSECTION Power Circuit Inspection

Circuit open Inspection
1. Ignition off & Engine off.
2. Disconnected "ATM solenoid valve" connector and PCM/TCM connector.
3. Measure resistance between power of ATM solenoid valve connector and power of TCM connector.
  Specification : Approx. 0 Ω
4. Is the measured resistance within specification?
  YES
  - Go to " 22. Circuit short Inspection" procedure.
  NO
  - Check circuit open of power and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
Circuit short Inspection
1. Ignition off & Engine off.
2. Disconnected "ATM solenoid valve connector and PCM/TCM connector".
3. Measure a resistance between power of ATM solenoid valve connector and chassis ground.
  Specification : Infinite
4. Is the measured resistance within specifications?
  YES
  - Substitute with a known-good PCM/TCM and check for proper operation. If the problem is corrected, replace PCM/TCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  NO
  - Check harness for circuit short. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.