SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2013SANTA FE XL PREMIUMREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSMART KEY CODE SAVING SYSTEM DIAGNOSISDTC P1699: IMMOBILIZER-TWICE OVERTRIALDTC INSPECTIONMONITOR GDS DATA
2013 Hyundai Santa Fe XL Premium

Monitor GDS Data

2013 Hyundai Santa Fe XL PremiumSECTION Monitor GDS Data
  1. IG KEY "ON" & Engine "OFF".
  2. Connect GDS and select ID Register
  3. Check Smart key status in "Vehicle S/W Management",  if DTC is retrieved.
    Fig 1: Display - FOB Key Registered, Smart Key PCM Learnt Status
    G09273796Courtesy of HYUNDAI MOTOR AMERICA
  4. Is the Smart key PCM learnt status?

    YES 

    • Wait for 1 hour until PCM status is unlock with IG ON.

      After PCM status is unlock, perform the key teaching procedure. Finally, go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Fault is intermittent caused by poor contact in Smart Key PCM and/or PCM's connector or was repaired and Smart key PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
    NOTE:
    • PIN code is programmed in Smart key PCM, Transponder.
      1. If the Smart key PCM is not registered with PIN, key teaching process is not proceeded.
      2. Registering PIN is available after Smart Key PCM is neutralized.
      3. Neutralization of Engine PCM is available with GDS (Registering PIN code)
      4. If the virgin engine PCM is installed on vehicle, Engine PCM is automatically programmed PIN code by Smart Key PCM.
      5. Registering PIN code is only possible for virgin or neutralized status.
    • All Learning procedure is able to do with a GDS in the vehicle's ignition key off state.
      • Smart Key PCM Learning
        1. Before learning procedure for FOB Key, Smart Key PCM should be registered PIN code first.
        2. In case of replacing Smart Key PCM, All of the keys should be newly registered again.
        3. In case that Smart Key PCM receives 3 times with wrong PIN, It is not allowed for neutralization and Key Teaching for 1 hour.
        4. If the battery is discharged during neutralization or Teaching, Timer will start again from beginning.

        Therefore, it is avoidable to wait for 1 hour.

        Fig 2: Checking Smart Key
        G09273797Courtesy of HYUNDAI MOTOR AMERICA
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.