Repair procedures: Inspection

2013 Hyundai Santa Fe Sport Base, FWDSECTION Inspection
  1. Connect the GDS on the Data Link Connector (DLC).
  2. Measure the output voltage of the RPS at idle and various engine speed.
    Condition Output Voltage (V)
    Idle Approx. 1.2
    1, 500 RPM 2.0 ~ 2.2
    6, 300 RPM Approx. 2.8
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.