Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2013SANTA FE SPORT 2.0T, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 13 (ENGINE CONTROL SYSTEM - 2.4L)ENGINE CONTROL MODULE (ECM)REPAIR PROCEDURESREMOVAL
2013 Hyundai Santa Fe Sport 2.0T, AWD
Repair procedures: Removal
2013 Hyundai Santa Fe Sport 2.0T, AWDSECTION Removal
WARNING: This page is about a different variant/trim than selected.
CAUTION:
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
[In the case of installing used ECM]
- Perform "ECM Neutral mode" procedure with GDS.
Refer to IMMOBILIZER SYSTEM .
- After finishing "ECM Neutral mode", perform "Key teaching" procedure with GDS.
Refer to IMMOBILIZER SYSTEM .
[In the case of installing new ECM]
Perform "Key teaching" procedure with GDS. Refer to IMMOBILIZER SYSTEM .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.