Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2013GENESIS COUPE 2.0T R-SPECREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM (DTC TROUBLESHOOTING) (1 OF 3) - 2.0LDTC P0197: ENGINE OIL TEMPERATURE SENSOR LOW INPUTSIGNAL CIRCUIT INSPECTION
2013 Hyundai Genesis Coupe 2.0T R-Spec
Signal Circuit Inspection
2013 Hyundai Genesis Coupe 2.0T R-SpecSECTION Signal Circuit Inspection
- IG KEY OFF.
- Disconnect OTS connector.
- Measure resistance between OTS signal terminal of OTS harness connector and chassis ground.
Specification: 5V
- Is voltage within specification?
YES
- Go to next Inspection procedure.
NO
- Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.