Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHYUNDAI2013GENESIS COUPE 2.0T R-SPECREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM (DTC TROUBLESHOOTING) (1 OF 3) - 2.0LDTC P0197: ENGINE OIL TEMPERATURE SENSOR LOW INPUTCOMPONENT INSPECTION

2013 Hyundai Genesis Coupe 2.0T R-Spec

Component Inspection

2013 Hyundai Genesis Coupe 2.0T R-SpecSECTION Component Inspection

OTS Simulation Inspect
1. IG KEY OFF
2. Disconnect OTS connector.
3. IG KEY ON
4. Perform voltage simulation to signal circuit of OTS.
  
  Fig 1: Scantool Screen Display - OTS Voltage Signal Simulation Test (2.3V)
  Courtesy of HYUNDAI MOTOR CO.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.