SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2013GENESIS COUPE 2.0T R-SPECREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM (DTC TROUBLESHOOTING) (1 OF 3) - 2.0LDTC P0196: ENGINE OIL TEMPERATURE SENSOR-RANGE/PERFORMANCEDTC DETECTING CONDITION
2013 Hyundai Genesis Coupe 2.0T R-Spec

DTC P0196: Engine Oil Temperature Sensor-Range/Performance: DTC Detecting Condition

2013 Hyundai Genesis Coupe 2.0T R-SpecSECTION DTC Detecting Condition
DTC DETECTING CONDITION CHART

Item Detecting Condition Possible Cause
DTC Strategy
  • Plausibility check
  • Faulty OTS
Enable Conditions Case1
  • difference between highest and lowest modeled oil Temp. < 30..100 °C
  • engine coolant Temp. > 85 °C
  • coolant Temp. (at start) < 53.25 °C
  • 6V
  • Failure not detected for DTCs
Case2
  • 6V
  • Failure not detected for DTCs
Threshold Value Case1
  • difference between highest and lowest modeled oil Temp. < 2..35 °C
Case2
  • modeled oil Temp. > 70 °C, measured oil Temp. < 20 °C, coolant Temp. (at start) < 40 °C
Case3
  • coolant Temp. <70 °C, measured oil Temp. > 100 °C
Diagnostic Time Case1
  • 10 sec
Case2
  • 15 sec
Case3
MIL On Condition
  • 2 Driving Cycles
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.