Control Circuit Inspection

2013 Hyundai Genesis Coupe 2.0T PremiumSECTION Control Circuit Inspection
WARNING: This page is about a different car, the 2012 Hyundai Genesis Coupe. However, it is still accessible from the selected car via links, so may be relevant.
  • Check for Short to Ground or Power in Control Circuit 
    1. IG KEY 'OFF'.
    2. Disconnect CCV harness connector.
    3. IG KEY 'ON'.
    4. Measure voltage between control terminal of CCV harness connector and chassis ground.

      Specification  : Approx. 4V

      Fig 1: Measuring Voltage Between Control Terminal Of CCV Harness Connector & Chassis Ground
      G00520366Courtesy of HYUNDAI MOTOR CO.
    5. Is voltage within the specification?

      YES 

      • Go to next Inspection procedure.

      NO 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.