Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2013GENESIS COUPE 2.0T PREMIUMREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXHEAD LAMP LEVELING DEVICE DTCS
2013 Hyundai Genesis Coupe 2.0T Premium
Head Lamp Leveling Device DTCS
2013 Hyundai Genesis Coupe 2.0T PremiumSECTION Head Lamp Leveling Device DTCS
HEAD LAMP LEVELING DEVICE DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| DTC C1212 | Vehicle Speed Sensor Failure |
| DTC C1255 | Rear Height Sensor |
| DTC C1260 | Steering Angle Sensor - Signal |
| DTC C1522 | Head Lamp Switch Fault |
| DTC C1604 | ECU Fault |
| DTC C1606 | ECU Software Error |
| DTC C1620 | First Step Not Completed |
| DTC C1621 | Excessive Operating Temp |
| DTC C2226 | Output Voltage Short to Battery or Short to Ground |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.