Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2013GENESIS COUPE 2.0T PREMIUMREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESELECTRONIC STABILITY CONTROL (ESC) SYSTEMTROUBLESHOOTINGABS DOES NOT OPERATEINSPECTION PROCEDURESCHECK THE GROUND CIRCUIT
2013 Hyundai Genesis Coupe 2.0T Premium
Check the ground circuit
2013 Hyundai Genesis Coupe 2.0T PremiumSECTION Check the ground circuit
- Disconnect the connector from the ESC control module.
- Check for continuity between terminals 13, 38 of the ESC control module harness side connector and ground point.
- Is there continuity?
YES Check the wheel speed sensor circuit.
NO Repair an open in the wire and ground point.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.