Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHYUNDAI2013GENESIS COUPE 2.0T PREMIUMREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSKEYLESS ENTRY AND BURGLAR ALARMREPAIR PROCEDURESINSPECTIONTRUNK LID OPEN SWITCH INSPECTION

2013 Hyundai Genesis Coupe 2.0T Premium

Trunk Lid Open Switch Inspection

2013 Hyundai Genesis Coupe 2.0T PremiumSECTION Trunk Lid Open Switch Inspection

Remove the trunk lid trim.
(Refer to "TRUNK LID ")
Disconnect the 3P connector from the actuator.

Fig 1: Identifying Trunk Lid Open Switch Connector & Terminals
Courtesy of HYUNDAI MOTOR CO.
Check for continuity between the terminals in each switch position according to Fig 2.

Fig 2: Trunk Lid Open Switch Continuity Chart
Courtesy of HYUNDAI MOTOR CO.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.