Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Ground Circuit Inspection
2013 Hyundai Equus UltimateSECTION Ground Circuit Inspection
- Check for open in harness
- IG "OFF"
- Disconnect wheel speed sensor connector and HECU connector.
- Measure resistance between ground terminal of wheel speed sensor harness connector and ground terminal of HECU harness connector.
Specification: Below approx. 1Ω
- Is the measured value within specifications?
YES
- Go to "GROUND CIRCUIT INSPECTION " procedure.
NO
- Repair open or short in signal circuit between HECU and wheel speed sensor and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Check for short in harness
- IG "OFF"
- Disconnect wheel speed sensor connector and HECU connector.
- Measure resistance between ground terminal of wheel speed sensor harness connector and chassis ground.
Specification: Infinite
- Is the measured value within specifications?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair short in the ground circuit between wheel speed sensor and HECU and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.