Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Verification of Vehicle Repair
2013 Hyundai Equus UltimateSECTION Verification of Vehicle Repair
After a repair, it is essential to verify that the fault is corrected.
- After connecting scantool select "DIAGNOSTIC TROUBLE CODES (DTCs)" mode.
- Clear recorded DTC using scantool.
- After selecting "DIAGNOSTIC TROUBLE CODES (DTCs)" mode and check if DTC is recorded again.
- Are any DTCs recorded?
YES
Go to the DTC guide of recorded NO. in scantool.
NO
System operates within specification.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.