Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2013EQUUS ULTIMATEREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSINTERIORCRASH PADREPAIR PROCEDURESREPLACEMENTAUDIO ASSEMBLY REPLACEMENT
2013 Hyundai Equus Ultimate
Audio Assembly Replacement
2013 Hyundai Equus UltimateSECTION Audio Assembly Replacement
- Remove the crash pad lower panel.
- Remove the center fascia panel.
- Loosen the audio assembly mounting screws, then remove the audio assembly (A).
- Disconnect the connector (B).
- Installation is the reverse the removal.NOTE:
- Make sure the connector is plugged in properly.
- Replace any damage clips.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.