Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2013EQUUS ULTIMATEREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINFOTAINMENTDRIVER INFORMATION SYSTEM (DIS) - HEAD UNIT DIAGNOSISDIAGNOSTIC TROUBLE CODES INDEX
2013 Hyundai Equus Ultimate
Diagnostic Trouble Codes Index
2013 Hyundai Equus UltimateSECTION Diagnostic Trouble Codes Index
DIAGNOSTIC TROUBLE CODES DESCRIPTIONS
| DTC | Description |
|---|---|
| DTC U1000 | Head Unit ECM Error |
| DTC U1003 | Temperature Sensor Signal Error in Head Unit |
| DTC U1006 | Low Voltage Detected |
| DTC U1007 | High Voltage Detected |
| DTC U1045 | Sticking Key on Central Control Panel |
| DTC U1065 | Sticking Key on Rear Armrest Controller |
| DTC U1401 | MOST Critical Unlock Detected |
| DTC U1500 | Wake up Line Short Circuit To Ground |
| DTC U1501 | Wake up Line Short Circuit To VCC |
| DTC U1750 | HDD Invalid Media |
| DTC U1751 | Function 'Delete Navigation database' Executed |
| DTC U1900 | GPS Antenna Line Break |
| DTC U1920 | DVD Drive Error |
| DTC U1940 | Front Display SDC Communication Error |
| DTC U1942 | Rear Display SDC Communication Error |
| DTC U1965 | Central Control Panel Serial Communication Error |
| DTC U1970 | Multimedia CAN Bus Off Error |
| DTC U1971 | Multimedia CAN Single Line Error |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.