Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2012VELOSTER STANDARD TRANSREPAIR AND DIAGNOSISRESTRAINTSAIR BAG, SRSSUPPLEMENTAL RESTRAINT SYSTEM CONTROL MODULE (SRSCM) & SENSORSSRS CONTROL MODULE (SRSCM)REPAIR PROCEDURESREMOVAL
2012 Hyundai Veloster Standard Trans
Repair Procedures: Removal
2012 Hyundai Veloster Standard TransSECTION Removal
- Remove the ignition key from the vehicle.
- Disconnect the battery negative cable and wait for at least three minutes before beginning work.
- Remove the floor console.
(Refer to the "CONSOLE ")
- Pull up the lock, of the SRSCM connector, the disconnect the connector (A and B).
- Remove the SRSCM mounting bolt and nuts from the SRSCM, then remove the SRSCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.