Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2011SANTA FE GLS, 3.5 G, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 6 (MANUAL TRANSAXLE SYSTEM)REPAIR PROCEDURESSERVICE ADJUSTMENT PROCEDUREBACK UP LAMP SWITCH INSPECTION
2011 Hyundai Santa Fe GLS, 3.5 G, AWD
Back Up Lamp Switch Inspection
2011 Hyundai Santa Fe GLS, 3.5 G, AWDSECTION Back Up Lamp Switch Inspection
WARNING: This page is about a different variant/trim than selected.
- Disconnect the back up lamp switch connector (A).
- Inspect the continuity of the switch. When the shift lever is in reverse range, it should have continuity.
- Replace the back up lamp switch, if necessary.
Tightening torque :
29.4~34.4 N.m (3.0~3.5Kgf.m, 21.7~25.3lb-ft)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.