Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2011SANTA FE GLS, 3.5 G, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 5 (AUTOMATIC TRANSAXLE CONTROL SYSTEM - A6MF2)INPUT SPEED SENSORREPAIR PROCEDURESREMOVAL
2011 Hyundai Santa Fe GLS, 3.5 G, AWD
Repair procedures: Removal
2011 Hyundai Santa Fe GLS, 3.5 G, AWDSECTION Removal
WARNING: This page is about a different variant/trim than selected.
- Remove the battery and the battery tray. (Refer to "Charging System ".)
- Remove the under cover (A).
- Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug. (Refer to "Automatic Transaxle System ".)
- Remove the valve body cover (A) and eyebolt (B).
Tightening torque:
- 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
- 34.3 ~ 44.1 N.m (3.5 ~ 4.5 kgf.m, 25.3 ~32.6 lb-ft)CAUTION: The gasket of the eyebolt use new one.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.