Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2011SANTA FE GLS, 3.5 G, AWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (1 OF 3) - G3.5 DOHCDTC P0196: ENGINE OIL TEMPERATURE SENSOR-RANGE/PERFORMANCEINSPECTION/REPAIRCOMPONENT INSPECTION
2011 Hyundai Santa Fe GLS, 3.5 G, AWD
Component Inspection
2011 Hyundai Santa Fe GLS, 3.5 G, AWDSECTION Component Inspection
- Check OTS resistance
- IG "OFF" and disconnect OTS connector.
- Measure resistance between signal and ground terminals of OTS connector after checking out the temperature of EOTS with scantool (Component Side)
Specification :
TEMPERATURE AND RESISTANCE SPECIFICATIONSTemperature(°C/°F) Resistance (kΩ) -40°C 52.15kΩ -20°C 16.52kΩ 0°C 6.0kΩ 20°C 2.45kΩ 40°C 1.11kΩ 60°C 0.54kΩ 80°C 0.29kΩ - Is the measured resistance within specification?
YES
- Go to VERIFICATION OF VEHICLE REPAIR .
NO
- Substitute with a known - good OTS and check for proper operation. If the problem is corrected, replace OTS and go to VERIFICATION OF VEHICLE REPAIR .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.