Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2011SANTA FE GLS, 3.5 G, AWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTILOCK BRAKE SYSTEM (ABS)/ELECTRONIC STABILITY CONTROL (ESC) DIAGNOSISDTC C1623: CAN TIME-OUT STEERING ANGLE SENSORSCANTOOL DIAGNOSTICSMONITOR SCANTOOL DATA
2011 Hyundai Santa Fe GLS, 3.5 G, AWD
Monitor Scantool Data
2011 Hyundai Santa Fe GLS, 3.5 G, AWDSECTION Monitor Scantool Data
- Connect scantool to Data Link Connector (DLC)
- Engine "ON".
- Turn the steering wheel to the left or right.
- Monitor the "STEERING ANGLE SNSR" parameters on the Scantool.
Courtesy of HYUNDAI MOTOR CO.
Normal Data
- Whenever steering wheel is turned, is the steering sensor's scantool data changed?
YES
- Fault is caused by having been repaired and HECU memory was not cleared. Clear the DTC and then go to VERIFICATION OF VEHICLE REPAIR .
NO
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.