Component Inspection

2011 Hyundai Santa Fe GLS, 3.5 G, AWDSECTION Component Inspection
  1. Ignition "OFF".
  2. Ignition "ON"
  3. Connect scantool and select "Diagnostic Trouble Codes (DTCs)" mode.
  4. Using a scantool, Clear DTC.
  5. Select "Diagnostic Trouble Codes (DTCs)" mode again.
  6. Are any DTCs present?

    YES 

    NO 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.