Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2011SANTA FE GLS, 3.5 G, AWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTILOCK BRAKE SYSTEM (ABS)/ELECTRONIC STABILITY CONTROL (ESC) DIAGNOSISDTC C1261: STEERING ANGLE SENSOR NOT CALIBRATEDINSPECTION/REPAIRCOMPONENT INSPECTION
2011 Hyundai Santa Fe GLS, 3.5 G, AWD
Component Inspection
2011 Hyundai Santa Fe GLS, 3.5 G, AWDSECTION Component Inspection
- Line up wheels like Fig 1.
- Perform the wheel alignment.
- Set the steering wheel so that the wheels point straight ahead.
- Go ahead and Go back the vehicle 2~3 times without holding steering wheel.
- Connect scantool to Data Link Connector (DLC).
- Go in Elec. Power Steering system.
- Perform ASP calibration. (Fig 2).
- Check the condition of "SAS 0 SET" by operating the vehicle (turn right and left at least 1 time)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.