SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2011SANTA FE GLS, 3.5 G, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM DIAGNOSIS (3 OF 3) - G3.5 DOHCDTC P061B: INTERNAL CONTROL MODULE TORQUE CALCULATION PERFORMANCEINSPECTION/REPAIRSYSTEM INSPECTION
2011 Hyundai Santa Fe GLS, 3.5 G, AWD

System Inspection

2011 Hyundai Santa Fe GLS, 3.5 G, AWDSECTION System Inspection
  • Check air leakage 
    1. Check contamination or installation of Gasket.
      • Check throttle body gasket.
      • Check gasket between intake manifold and surge tank.
      • Check contamination or clog by foreign material of gasket between intake manifold and injector.
      • Check contamination or open stuck resulting from foreign material between surge tank and PCSV.
    2. Is there any air leakage?

      YES 

      NO 

      • Go to  2.
  • Check exhaust system for clogging 
    1. Check exhaust system.
      • Clogged or broken muffler.
      • Broken catalyst.
    2. Is the exhaust system clogged?

      YES 

      • Go to  1.

      NO 

  • Check exhaust system for clogging 
    1. IG "OFF".
    2. Remove air hose between throttle body and airflow sensor.
    3. Check if throttle valve is stuck by foreign material.
    4. Is the throttle valve normal?

      YES 

      NO 

      • After getting rid of foreign material, check that throttle valve is normal. And check for proper operation.

        If the problem is corrected, replace ETC and then go to VERIFICATION OF VEHICLE REPAIR .

    • Procedure of ETS Initialization
      1. Erase the trouble codes on ECM.
      2. Turn the ignition key off and keep this condition until the main relay is turned off. (It will take 10sec.)
      3. Turn ignition key on more than 1second to record the throttle motor position on the EEPROM.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.