Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2011GENESIS 3.8REPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSBODY CONTROL - FRONT AREA MODULE DIAGNOSIS
2011 Hyundai Genesis 3.8
Body Control - Front Area Module Diagnosis
2011 Hyundai Genesis 3.8SECTION Body Control - Front Area Module Diagnosis
- Diagnostic Trouble Code Index
- DTC B1602: CAN Error
- DTC B1603: CAN Communication Bus Off
- DTC B1905: Rain Sensor Fault 1
- DTC B1906: Rain Sensor Fault 2
- DTC B1907: Rain Sensor Fault 3
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.