Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2011EQUUS SIGNATUREREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM DIAGNOSIS (1 OF 3)DTC P0112: INTAKE AIR TEMPERATURE SENSOR 1 CIRCUIT LOW INPUTINSPECTION/REPAIRW/HARNESS INSPECTIONSIGNAL CIRCUIT INSPECTION
2011 Hyundai Equus Signature
Signal Circuit Inspection
2011 Hyundai Equus SignatureSECTION Signal Circuit Inspection
- Check Short To Ground In Harness
- IG "OFF" and disconnect IATS connector.
- IG "ON".
- Measure resistance between signal terminal of IATS harness connector and ground terminal of MAFS harness connector. (Measurement "B")
Specification: Approx. 3.3V
- Is the measured voltage within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair short to ground in harness and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.