Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Inspection
2011 Hyundai Equus SignatureSECTION Component Inspection
- Check ESC OFF Switch
- IG "OFF"
- Disconnect ESC OFF Switch connector.
- Press the ESC OFF Switch.
- Measure resistance between both ends of the ESC OFF Switch connector while pressing the button.
Specification : Below approx. 1.0Ω
- Is the measured value within specifications?
YES
- This fault may be intermittently caused by a poor connection of the ESC OFF switch.
- Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known-good ESC OFF Switch and check for proper operation.
- If problem is corrected, replace ESC OFF Switch and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.