Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Inspection
2011 Hyundai Equus SignatureSECTION Component Inspection
- IG "OFF" and connect scantool to Data Link Connector(DLC).
- IG "ON" and clear DTC.
- Start Engine.
- Perform the latching order by pushing the EPB button or using scantool.
- Again using scantool, Check DTC present.
- Is the same DTC shown, agian?
YES
- Substitute with a known-good EPB ASS'Y and check for proper operation. If problem is corrected, replace EPB ASS'Y and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Fault is intermittent caused by poor connection or was repaired and EPB ECU memory was not cleared.
- Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.