Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2011EQUUS SIGNATUREREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSCRUISE CONTROL SYSTEMCRUISE CONTROL SWITCHREPAIR PROCEDURESINSPECTIONMEASURING RESISTANCE
2011 Hyundai Equus Signature
Measuring Resistance
2011 Hyundai Equus SignatureSECTION Measuring Resistance
- Disconnect the cruise control switch connector from the control switch.
- Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).RESISTANCE REFERENCE CHART
Function switch Terminal Resistance CANCEL 3-4 0Ω SET/- 3-4 220Ω RES/+ 3-4 1130Ω ON/OFF 1-3 3900Ω - If not within specification, replace switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.