Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2011ELANTRA TOURING L4-2.0LREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SWITCHSERVICE AND REPAIR
2011 Hyundai Elantra Touring L4-2.0L
Cruise Control Switch: Service and Repair
2011 Hyundai Elantra Touring L4-2.0LSECTION Service and Repair
Removal
1. Remove the air bag module assembly.
2. Disconnect the auto cruise control main switch connector.
3. Remove the auto cruise control main switch assembly.
4. To install, reverse the removal procedure.
Inspection
1. Operate the switches and check for continuity between the terminals.
2. If continuity is not as specified, replace the switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.