Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Hyundai Azera GLSFACTORY OEM SERVICE PROCEDURE
Component Inspection
■ Check Multifunction switch
- Connect scantool to Data Link Connector (DLC).
- Ignition "ON" & engine "OFF".
- Substitute with a known-good Multifunction switch and Check if the DTC is erased.
- Is the DTC erased?
YES
- substitute with a known-good Multifunction switch and check for proper operation. If the problem is corrected, replace Multifunction switch and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to 1Check BCM procedure.
■ Check BCM
- Connect scantool to Data Link Connector (DLC).
- Ignition "ON" & engine "OFF".
- Substitute with a known-good BCM and Check if the DTC is erased.
- Is the DTC erased?
YES
- Substitute with a known-good BCM and check for proper operation.
If the problem is corrected, replace BCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Substitute with a known-good BCM and check for proper operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
