Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Hyundai Azera GLSFACTORY OEM SERVICE PROCEDURE
Body Control - Integrated Memory System
- B1602 CAN BUS Physical Error
- B1603 CAN Communication Bus Off
- B1605 CAN Time - out DDM
- B1606 CAN Time - out ADM
- B1607 CAN Time - out P SEAT
- B1608 Lost Communication Between BCM and SCM
- B1629 Lin Reception Error
- B1630 Lin Transmission Error
- B1901 Auto Light Out Of Range
- B1905 Rain Sensor Fault 1
- B1906 Rain Sensor Fault 2
- B1907 Rain Sensor Fault 3
- B1910 Outside Mirror - Left Horizontal Motor or Sensor Error
- B1911 Outside Mirror - Left Vertical Motor or Sensor Error
- B1912 Outside Mirror - Right horizontal Motor or Sensor
- B1913 Outside Mirror - Right vertical Motor or Sensor
- B1954 Slide Motor Or Sensor Error
- B1955 Recline Motor Or Sensor Error
- B1956 Front Height Motor Or Sensor Error
- B1957 Right Rear Height Motor Or Sensor Error
- B1959 Tilt Position Sensor Error
- B1960 Tele Position Sensor Error
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
