Monitor Scan Tool Data

2009 Hyundai Tucson Limited, 2.0 BSECTION Monitor Scan Tool Data
  1. Connect scan tool to Data Link Connector (DLC).
  2. Engine "ON"
  3. Monitor the "DIRECTION POTENTIO.DR." parameter on the scan tool while operating mode switch.
    Fig 1: Monitoring "DIRECTION POTENTIO.DR." Parameter
    G06232891Courtesy of HYUNDAI MOTOR CO.
  4. Is the DTC B1250 present and is parameter of "DIRECTION POTENTIO.DR." fixed?

    * Parameter of "DIRECTION POTENTIO.DR." will be fixed at 100%(or any value above 90%), or 0% (or any value below 10%), if there is any fault in Driver Direction Potentiometer.

    YESΒ 

    NOΒ 

    • The electrical systems are made up of many harness and connectors. Many kinds of fault are caused by poor connection of sensors and terminals. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIRΒ " procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.